Miller Electric INTEGRA 201/241 manual Installing Drive Roll and Wire Inlet Guide

Page 11

2-5. Installing Drive Roll and Wire Inlet Guide

1Securing Screw

2Inlet Wire Guide

Loosen screw. Slide tip as close to drive rolls as possible without touch- ing. Tighten screw.

3Wire Tension Wheel

4Drive Roll

Install correct drive roll for wire size and type.

5 Drive Roll Tension Assembly

Turn nut one click to secure drive roll.

ST-150 227-C

2-6. Installing Wire Spool and Adjusting Hub Tension

When a slight force is needed to turn spool, tension is set.

Tools Needed:

15/16 inST-072573-B

2-7. Electrical Service Guide

	201	241

Input Voltage	230	230

Input Amperes at Rated Output	26	35

Max Recommended Standard Fuse or Circuit Breaker Rating in Amperes	26	35

** Input Conductor Size in mm2	4	4
** Grounding Conductor Size in mm2	4	4

** Power cord supplied with the unit is sized for 230V operation. Larger power cord may be required for cable lengths greater than 3 meters. C onsult national and local regulations.

OM-188 414 Page 7

Image 11

Contents Description OM-188 414CProcesses From Miller to You Table of Contents Standards DirectivesElectric Shock can kill Symbol UsageMarks a special safety message Arc Welding HazardsBuildup of GAS can injure or kill ARC Rays can burn eyes and skinWelding can cause fire or explosion Flying Metal can injure eyesPrincipal Safety Standards About Pacemakers EMF InformationDuty Cycle and Overheating InstallationSpecifications Model Installing Gas SupplyVolt-Ampere Curves Electrical Service Guide Installing Drive Roll and Wire Inlet GuideInstalling Wire Spool and Adjusting Hub Tension Installing Work Clamp Selecting a Location and Connecting Input PowerControls OperationUnit Overload Maintenance and TroubleshootingRoutine Maintenance Circuit Breaker CB1Trouble Remedy TroubleshootingIntegra Electrical DiagramCode Dwg Parts ListCommon Parts Assembly Dia Code DwgDia Qty Code Dwg 201 Main AssemblyDia Effective January 1 Miller Electric Mfg. Co Owner’s Record