3.Connect Load Bank cord to the ac power source. Be sure to use appropriate cord when Load Bank has both 120 and 240 volt cords installed.
4.Place 120 VOLT LOAD/240 VOLT LOAD selector switch in proper position (see Section
5.Turn on or start the ac power source.
6.Check pilot lights for proper input voltage load selection (see Section
7.Rotate AMPERAGE load switches to select desired ampere load value (see Section
8.Compare meter readings with ac power source Owner’s Manual to check for compliance with specifications.
6-2. SHUTTING DOWN
1.Rotate AMPERAGE load switches to the OFF position.
2.Shut down the power source.
3.Disconnect Load Bank cord from power source, and place cord in the Load Bank cord storage.
SECTION 7 – MAINTENANCE
IMPORTANT: Every six months inspect the labels on the unit for legibility. All precautionary labels must be maintained in a clearly readable state and replaced when necessary. See Parts List for part number of precautionary labels.
7-1. INSPECTION AND UPKEEP
Usage and shop conditions will determine the frequency and type of maintenance. Inspect equipment every six months as follows:
WARNING: ELECTRIC SHOCK can kill.
• Do not touch live electrical parts.
•Shut down and disconnect Load Bank from auxiliary power source before inspecting, maintaining, or servicing.
MOVING PARTS can cause serious injury.
•Keep clear of moving parts.
HOT SURFACES can cause severe burns.
•Allow cooling period before servicing.
Maintenance to be performed only by qualified persons.
1.Remove grease and grime from components; remove moisture from electrical parts and cords.
2.Check cord terminal connections. Be sure that connections are clean and tight.
7-2. INTERNAL CLEANING
WARNING: ELECTRIC SHOCK can kill.
• Do not touch live electrical parts.
•Shut down and disconnect Load Bank from auxiliary power source before inspecting, maintaining, or servicing.
HOT SURFACES can cause severe burns.
•Allow cooling period before servicing.
Blow out or vacuum the dust and dirt from around the internal components. Do this annually depending on the location of the unit and the amount of dust and dirt in the atmosphere. If dirty or dusty conditions are present, clean unit monthly. The outer enclosure should be removed and a clean, dry airstream or vacuum suction should be used for this cleaning operation.