E N G L I S H
Using an extension cable
Always use an approved extension cable suitable for the power input of this tool (see technical data). Before use, inspect the extension cable for signs of damage, wear and ageing. Replace the extension cable if damaged or defective.
When using a cable reel, always unwind the cable completely. Use of an extension cable not suitable for the power input of the tool or which is damaged or defective may result in a risk of fire and electric shock.
CARTON CONTENTS
The carton contains:
1Rotary tool
1Wrench
1Accessories and application guide
1Instruction manual
◆Carefully unpack all parts.
◆Please note that additional items may be found in the carton, depending on the letter suffix following the catalogue number of your tool.
OVERVIEW (fig. A)
1.On/off switch
2.Spindle lock
3.Speed control knob
4.Collet
5.Collet nut
6.Spindle
7.Suspension hook
ASSEMBLY
Before assembly, make sure that the tool is switched off and unplugged.
Fitting and removing accessories (fig. B)
◆Make sure that the tool is switched off and unplugged.
◆Activate the spindle lock (2) by setting it to position B as shown.
◆Slacken the collet nut (5) by turning counterclockwise.
◆Insert the shaft of the accessory into the collet as far as it will go.
◆Securely tighten the collet nut.
◆Release the spindle lock (2) by setting it to position A as shown.
◆Make sure that the collet size matches the shaft diameter.
◆Never tighten the collet nut without an accessory in the collet.
◆Tighten and loosen the collet by hand if possible. If necessary, use the supplied wrench to loosen the collet. Do not use any tools that could mark the finish or break the collet.
Replacing collets (fig. C)
This tool is supplied with a 3.2 mm collet. Different sizes are available as an accessory to accomodate a wide range of accessories. To fit the correct collet for the accessory to be used:
◆Make sure that the tool is switched off and unplugged.
◆Activate the spindle lock (2) by setting it to position B as shown.
◆Remove the collet nut (5) by turning counterclockwise.
◆Pull the collet off the spindle (6).
◆Place the new collet into the spindle.
◆Loosely screw the collet nut onto the spindle.
◆Release the spindle lock (2) by setting it to position A as shown.
USE
Let the tool work at its own pace.
Do not overload.
◆If you are not sure about the correct speed setting, start with a low speed setting and gradually increase it until you find the optimum setting.
◆Where indicated, never exceed the speed rating of an accessory. The wire brush accessory must not be used above speed setting 3 (15,000
Variable speed control (fig. D)
The variable speed control allows you to adapt the speed of the tool to the application.
8
RT650_UK.PM5 | 8 |