indicate it is acceptable for outdoor use.
6.Make sure the extension cord is properly wired and in good electrical condition. Always replace a damaged extension cord or have it repaired by a qualified electrician before using it.
7.Protect the extension cords from sharp objects, excessive heat, and damp or wet areas.
RECOMMENDED MINIMUM WIRE GAUGE FOR EXTENSION CORDS*
(110/220 VOLT)
NAMEPLATE | EXTENSION CORD | ||||||
| LENGTH |
| |||||
AMPERES |
|
| |||||
25’ | 50’ | 75’ | 100’ | 150’ | |||
(at full load) | |||||||
|
|
|
|
| |||
|
|
|
|
|
| ||
0 – 2.0 | 18 | 18 | 18 | 18 | 16 | ||
2.1 | – 3.4 | 18 | 18 | 18 | 16 | 14 | |
3.5 | – 5.0 | 18 | 18 | 16 | 14 | 12 | |
5.1 | – 7.0 | 18 | 16 | 14 | 12 | 12 | |
7.1 – 12.0 | 18 | 14 | 12 | 10 | - | ||
12.1 | – 16.0 | 14 | 12 | 10 | - | - | |
16.1 | – 20.0 | 12 | 10 | - | - | - | |
* Based on limiting the line
TABLE A voltage drop to five volts at 150% of the rated amperes.
Symbology
Double Insulated
| Canadian Standards Association |
|
|
| Underwriters Laboratories, Inc. |
|
|
V~ | Volts Alternating Current |
A | Amperes |
| |
|
|
n0 xxxx/min. | No Load Revolutions per Minute |
(RPM) |
Specifications
Electrical | 120 V~ / 60 Hz / 620 W | |
Requirements | ||
Speed | n0 750/min | |
Blows Per | 2920 BPM | |
Minute | ||
| ||
Capacity | 1” | |
|
| |
Chuck Type | SDS | |
Rotation | Clockwise | |
| For drilling stone, concrete, and | |
Applications | other hard and brittle materials. | |
| For chiseling. | |
| Wrench | |
| SDS Drill Bits: 10mm/12mm | |
| 14mm/22mm | |
| ||
Accessories | Container of Grease | |
| Carbon Brush Set | |
| Depth Gauge Rod | |
| Auxiliary Handle | |
| Carrying Case | |
| E194601 |
Unpacking
When unpacking, check to make sure that the item is intact and undamaged. If any parts are missing or broken, please call Harbor Freight Tools at the number shown on the cover of this manual as soon as pos- sible.
SKU 97743 | For technical questions, please call | Page 8 |