Chiseling
Changing Chisel Bits
1. | Grease the bit shank before installing. | 4. | Rotate the Mode Selector so the Adjust |
2. | Pull back on the Chuck and insert the Bit. Make |
| Chisel Setting is in the ON position. Rotate |
| the bit to the desired angle then rotate the | ||
| sure it slides all the way into the opening. |
| Mode selector to the Hammer setting. |
3. | Release the Chuck. | 5. | Check that the bit is secured in place. It should |
|
|
| not be able to be pulled out of the Chuck. |
Chisel Operation
SAFETY
1.Adjust the Auxiliary Handle as needed.
2.Plug in the Power Cord.
3.Squeeze and hold the Trigger to turn on the Rotary Hammer.
4.Allow the Rotary Hammer to reach full speed before contacting the work surface.
5.When finished, to prevent accidents, release the Trigger and disconnect its power supply after use. Pull back on the Chuck then remove the bit from the Chuck. Clean, then store
the tool indoors out of children’s reach.
SETUP
OPERATION
MAINTENANCE
Item 69334 | For technical questions, please call | Page 11 |