DM 2610934164
Assembly
Always unplug Rotary Tool before ! WARNING changing accessories, changing
collets or servicing your Rotary Tool.
SHAFT LOCK
BUTTON
COLLET
WRENCH TO TIGHTEN
COLLET
NUT
COLLET
TO LOOSEN
COLLET
To loosen, first press shaft lock button and rotate the shaft by hand until the lock engages the shaft preventing further rotation.
! CAUTION | Do not engage lock while the | |
Rotary Tool is running. | ||
|
With the shaft lock engaged use the collet wrench to loosen the collet nut if necessary. Change accessories by inserting the new one into the collet as far as possible to minimize runout and unbalance. With the shaft lock engaged, finger tighten the collet nut until the accessory shank is gripped by the collet. Avoid excessive tightening of the collet nut.
COLLETS
Four different size collets (see illustration), to accommodate different shank sizes, are available for your Rotary Tool. To install a different collet, remove the collet nut and remove the old collet. Insert the unslotted end of the collet in the hole in the end of the tool shaft. Replace collet nut on the shaft. Always use the collet which matches the shank size of the accessory you plan to use. Never force a larger diameter shank into a collet.
BALANCING ACCESSORIES
For precision work, it is important that all accessories be in good balance (much the same as the tires on your automobile). To true up or balance an accessory, slightly loosen collet nut and give the accessory or collet a 1/4 turn. Retighten collet nut and run the Rotary Tool. You should be able to tell by the sound and feel if your accessory is running in balance. Continue adjusting in this fashion until best balance is achieved. To maintain balance on abrasive wheel points, before each use, with
COLLET IDENTIFICATION CHART — Collet sizes can be identified by the rings on the back end of collet.
0,8mm Collet has one (1) ring. 1,6mm Collet has two (2) rings. 2,4mm Collet has three (3) rings. 3,2mm Collet has no rings.
COLLET
NUT
|
|
| IDENTIFICATION |
|
|
| RINGS |
480 |
|
|
|
3,2mm | 481 |
|
|
COLLET | 482 | 483 | |
| 2,4mm | ||
| COLLET | 1,6mm | 0,8mm |
|
| COLLET | COLLET |
|
|
|
the wheel point secured in the collet, turn on the Rotary Tool and run the 415 Dressing Stone lightly against the revolving wheel point. This removes high spots and trues up the wheel point for good balance.
The hanger is provided for the use of hanging your tool while using the
FLEX-SHAFT TO ROTARY TOOL INSTALLATION
To properly attach the
Step 1. Press the Shaft lock button, unscrew and remove the collet nut.
Step 2. Unscrew the housing cap from the tool.
Page 6