DM 2610934164
Dremel Accessories
! | WARNING | Use only Dremel Tested, High Performance Accessories. Other accessories are not | |
designed for this tool and may lead to personal injury or property damage. | |||
|
|
The number and variety of accessories for the Rotary Tool are almost limitless. There is a category suited to almost any job you might have to do — and a variety of sizes and shapes within each category which en- ables you to get the perfect accessory for every need.
Refer to the DREMEL ACCESSORY ORDER FORM for illustrations of the accessories available. These accessories may be found at your local hardware, hobby or home center dealers.
Collets
If you expect to use a variety of accessories, we recommend that in the beginning you purchase a complete set of four collets. Store these so that you will have the proper size of collet for any accessory or drill bit you want to use. Currently, the 3,2mm, 2,4mm,0,8mm and 1,6mm collets accommodate all of the available Dremel accessories. 3,2mm collets are included in most rotary tool kits.
Mandrels
A mandrel is a shank with a threaded or screw head, which are required when you use polishing accessories, cutting wheels, sanding discs, and polish- ing points. The reason mandrels are used is that sanding discs, cutting wheels and similar accessories must be replaced frequently. The mandrel is a per- manent shank, allowing you to replace only the worn head when necessary, thus saving the expense of replacing the shaft each time.
Screw Mandrel No. 401
This is a screw mandrel used with the felt polishing tip and felt polishing wheels. 3,2mm shank.
Small Screw Mandrel No. 402
This is a mandrel with a small screw at its tip, and is used with emery and fiberglass cutting wheels, sanding discs and polishing wheels. 3,2mm shank.
Threaded Tip Mandrel No. 424
This is a mandrel with a threaded tip which threads into the polishing point accessory No. 427. 3,2mm shank.
High Speed Cutters
Available in many shapes, high speed cutters are used in carving, cutting and slotting in wood, plastics and soft metals such as aluminum, copper and brass. These are the accessories to use for freehand routing or carving in wood or plastic, and for precision cutting. Made of high quality steel. 3,2mm shank.
Tungsten Carbide Cutters
These are tough,
Engraving Cutters
This group has a wide variety of sizes and shapes, and are made for intricate work on ceramics (greenware), wood carvings, jewelry and scrimshaw. They often are used in making complicated printed circuit boards. They should not be used on steel and other very hard materials but are excellent on wood, plastic and soft metals. 2,4mm shank.
Structured Tooth
Tungsten Carbide Cutters
Fast cutting,
Aluminum Oxide Grinding Stones (red/brown)
Round, pointed, flat — you name the shape and there is one available in this category. These are made of aluminum oxide and cover virtually every possible kind of grinding application. Use them for sharpening lawn mower blades, screwdriver tips, knives, scissors, chisels and other cutting tools. Use to remove flash from metal castings, deburring any metal after cutting, smoothing welded joints, grinding off rivets and removing rust. These grinding stones can be resharped with a dressing stone. In machine shops, high speed drills and cutters normally are ground with aluminum oxide wheels. 3,2mm shank.
Silicon Carbide Grinding Stones (blue/green)
Tougher than aluminum oxide points, these are made especially for use on hard materials such as glass and ceramics. Typical uses might be the removal of stilt marks and excess glaze on ceramics and engraving on glass. 3,2mm shank.
Diamond Wheel Points
Excellent for fine detail work on wood, jade, ceramic, glass and other hard material. Bits are covered with diamond particles. 2,4mm shanks.
Page 17