6.Position the drill bit at the place to be drilled and squeeze the Trigger. The tool is variable speed, and will rotate and hammer faster as the Trigger is progressively squeezed.
7.When the forward end of the Depth Gauge Rod contacts the work surface, you know the hole is the desired depth. Release the Trigger to stop the operation of the tool, and withdraw the bit from the hole.
For Use as a Drill:
1.Move the Selector Switch to the Drill setting. Please see picture below for reference. This setting will allow the drill to turn but not hammer.
2.Select and install an appropriate drill bit. Follow the instructions on page 7 for installing an
3.Start the drill by squeezing the trigger to be sure that the drill bit is properly centered in the Chuck. Always use 2 hands when using this tool.
4.Position the drill bit at the appropriate point on the workpiece and squeeze the trigger to start the drill operating. The tool is variable speed, and will rotate faster as the Trigger is progressively squeezed.
5.When the desired depth has been reached, release the Trigger to stop the operation of the tool, and withdraw the bit from the hole.
NOTE: This tool is reversible. If the drill bit does not withdraw easily from the hole, you may reverse the rotation to help it come out. With the tool stopped, move the Forward- Reverse Switch from right to left. Then squeeze the trigger, the drill will operate in reverse. As needed, stop the operation of the tool, and press the
Hammer Drill
Hammer Only | Drill Only | ||
|
|
|
|
The Hammer Drill Selector Switch
SKU 93722 | For technical questions please call | Page 9 |