OPERATIONS
Read the manual before operation. Become familiar with this tool, its safety instructions, and its operation before beginning any work. Serious personal injury may result if safety or operational information is not understood or followed.
Installing Bits
The Model H8210 uses bits with a 13/32" (10mm) diameter shaft. See the Grizzly catalog or www.grizzly.com for a complete listing of available bits and accessories.
Like all tools there is potential danger when operating this tool. Accidents are frequently caused by lack of familiarity or failure to pay attention. If normal safety precautions are overlooked or ignored, serious personal injury may occur.
To install a bit:
1.DISCONNECT THE AIR HAMMER FROM AIR SUPPLY!
2.Thread the retainer spring on the air hammer cylinder.
3.Insert the bit by bending the retainer spring out of the way of the cylinder bore and slide the bit in as shown in
Figure 2.
Note: If you have difficultly bend- ing the retainer spring to fit the bit, remove the spring and insert the bit into the spring prior to threading it on the hammer.