To maintain the effectiveness of the double insulation system, follow the precautions described below:
1.Always contact your dealer or an authorized service center when assembling, disassembling or replacing parts other than accessories or carbon brushes. Improper assembly and/or replacement with wrong parts may result in eliminating the double
2.Clean the exterior of the power tool with a soft cloth moistened with soapy water, and dry thoroughly. Chloric solvent, gasoline, and thinner will cause plastic components to dissolve.
REPLACEMENT PARTS
When servicing use only identical replacement parts.
PARTICULAR PRECAUTIONS ON USING DEMOLITION HAMMER
In addition to the precautions mentioned above, following particular precautions for this Demolition Hammer should be followed.
1.Wear earplugs to protect your ears during operation.
2.Do not touch the bit during or immediately after operation. The bit becomes very hot during operation and could cause serious burns.
3.Before starting to break, chip or drill into a wall, floor or ceiling, thoroughly confirm that such items as electric cables or conduits are not buried inside.
NAME OF PARTS
| Handle | Switch trigger | |
|
| ||
|
| Tail cover | |
Front cover |
| Hexagon socket | |
|
| hd. bolt (M5 x 10) | |
|
| Housing cover | |
| Housing | Name plate | |
Retainer | Side handle | ||
| |||
|
| Bolt, Spring lock washer | |
| Fig. 1 | (M8 x 30) | |
|
|
NOTE:
Install the side handle with the supplied 4 bolts and 4 spring lock washers. Tighten the bolts securely with the supplied wrench.
3