NOTE:
Use a manual hammer to open/close the retainer as it is too heavy to move by hand.
Fig. 2 | Fig. 3 |
NOTE:
When removing the accessory, such as a bull point, a cutter etc., follow the above procedure in reverse order.
OPERATION
1.Pull the trigger switch after applying the tip of the bit to the crushing position.
In some cases, it is necessary to punch the tip of the bit against the crushing position forcibly in order to begin the striking stroke.
This is not due to malfunction of the power tool. It means that the safe guard mechanism against
2.Operate this demolition hammer by utilizing its own weight. The performance will not be better even if it is pressed or thrust forcibly against the work surface.
Hold this demolition hammer with a force just sufficient to counteract the reaction.
CAUTION:
Sometimes the power tool does not begin the striking stroke even when the motor rotates because oil has become thick.
If the power tool is used at low temperatures or if it is used after a long idle time, this demolition hammer should be kept running for about five minutes in order to warm it up.
OIL FEEDING
CAUTION:
Prior to oil feeding, always disconnect the plug from the power supply receptacle. Since an oil chamber is built in this demolition hammer, it can be used for approximately 20 days without supplying oil, assuming that this demolition hammer is used continuously 3 ~ 4 hours a day.
Feed oil into the oil tank as described below before using this demolition hammer. (See Figs 5 and 6)
1.Feed oil without fail before no oil is visible in the oil gauge window when this demolition hammer is held upright.
2.Before feeding oil, remove the oil gauge with the provided wrench. Be careful not to
lose the rubber packing attached under the oil gauge. | 8 |