Billy Goat F1301H, F901S, F901H Operation, If Your Unit Fails to Start See Troubleshooting on

Page 10

FORCE BLOWER Owner’s Manual

OPERATION

Like all mechanical tools, reasonable care must be used when operating machine.

Inspect machine work area and machine before operating. Make sure that all operators of this equipment are trained in general machine use and safety.

PUT OIL IN ENGINE BEFORE STARTING

STARTING

ENGINE: See engine manufacturer’s instructions for type and amount of oil and gasoline used. Engine must be level when checking and filling oil and gasoline.

FUEL VALVE: Move fuel valve to "ON" position (when provided on engine).

STOP SWITCH: Located on the engine. "ON" position.

CHOKE: Operated with choke lever on side of engine.

THROTTLE: Controlled by throttle lever on the handle. Move remote throttle control to fast position. Pull starting rope to start engine.

ENGINE SPEED: Under normal conditions, operate at minimum throttle to accomplish your current cleaning task.

IF YOUR UNIT FAILS TO START: See Troubleshooting on page 13.

HANDLING & TRANSPORTING:

Using two people to lift machine is recommended. Lift holding the handle and handle brace. Secure in place during transportation. See F901 and F1301 series specifications on page 3 for unit weight.

Do not use the front grill as an anchor point when securing the unit for transport.

Never lift the machine while the engine is running.

BLOWING OPERATION

Your Billy Goat Force blower is equipped with an air director cone and the patented Aim-N-Shoot TM control lever to allow the operator to direct the air stream up or down as required to assist in moving debris. This feature is extremely useful when debris has piled up to the point that it cannot be blown any farther. The air stream can be directed upward to blow the top of the debris pile over and allow the operator to continue moving more debris farther.

Part No 440021

10

Form No F071307B

Image 10
Contents Billy Goat Force Blower Contents About this ManualSpecifications F901S F901H F1301H Serial Plate DataGeneral Safety Instructions and Symbols Form No F071307B Vibration Data SoundIntended USE Instruction Labels Engine LabelsPacking Checklist Parts BAG Literature AssyAssembly Figure aIf Your Unit Fails to Start See Troubleshooting on OperationAdjusting AIR Director Maintenance Periodic MaintenanceTroubleshooting Warranty Claim ProcedureIllustrated Parts List Parts List F1301H F901H F901SMaintenance Record