Billy Goat F901S, F1301H, F901H owner manual Assembly, Figure a

FORCE BLOWER Owner’s Manual

ASSEMBLY

1.Follow the steps in figures A and B, then securely tighten all hardware shown. 2.Connect spark plug wire.

Figure A Figure B

The hardware for attaching the upper handle to the lower is in the parts bag. Install upper handle (item 30), to preassembled lower handle (item 28) by sliding the upper over and down the outside of the lower handle. Using bolt (item #36), washers (item #10) & lock nut (item #11) to install upper handle to lower handle. Finish installing the other side of the upper handle assembly using screw and lock nut provided.

The throttle control and will be attached to the throttle arm on the engine and wrapped around the engine for shipping. Unwrap and secure throttle control (item #31) to upper handle with screws (item #17). Screws will already be mounted in handle, simply remove and use to mount the throttle control securing the cable with two Ty-wraps. The Aim-and-Shoot TM is not attached, you will need to unroll the cable and attach the ball end to the lever and seat the cable end into the hole on the saddle clamp, with the cable running through the slot. To keep the cable from being damaged use three ty-wraps (item 74) to secure it to the handle as shown making sure that the cable is not rubbing against the tire.

Two ½” open ended wrenches

Part No 440021

One 5/16 open ended wrench

9 Form No F071307B