Chauvet 56-24UVB user manual Pin to 5-Pin Conversion Chart, Setting up a DMX Daisy Chain

Page 14

3-Pin to 5-Pin Conversion Chart

If you use a controller with a 5-pin DMX output connector, you will need to use a 5-pin to

3-pin adapter. The chart below details a proper cable conversion:

3-PIN TO 5-PIN CONVERSION CHART

Conductor

3-Pin Female (Output)

Ground/Shield

Pin 1

Data ( - ) signal

Pin 2

Data ( + ) signal

Pin 3

Not used

 

Not used

 

5-Pin Male (Input)

Pin 1

Pin 2

Pin 3

Pin 4

Pin 5

Setting up a DMX Daisy Chain

1.Connect the (male) 3-pin connector side of the DMX cable to the output (female) 3-pin connector of the controller.

2.Connect the end of the cable coming from the

controller which will have a (female) 3-pin connector to the input connector of the next fixture consisting of a (male) 3-pin connector.

3.Then, proceed to connect from the output as stated above to the input of the following fixture and so on.

Universal DMX Controller

This drawing provides a general illustration of the DMX input/output panel of a lighting fixture.

Continue the link

5. Appendix

14

9/13/2010 2:33 PM

Image 14
Contents LED PAR 56-24UVB Table of Contents Unpacking Instructions What is includedBefore YOU Begin Manual ConventionsSafety Instructions Introduction Product OverviewPower Linking SetupAC Power Mounting Control Panel Functions Configuring the Starting AddressOperating Instructions Menu MapMaster/Slave Mode Sound-Active, Auto Mode DMX OperationSound-Active DMX Channel ValuesAutomatic Static DimmerGeneral Troubleshooting AppendixData Cabling DMX PrimerFixture Linking Daisy Chain DMX Data CableCable Connectors Setting the Starting AddressPin to 5-Pin Conversion Chart Setting up a DMX Daisy ChainClaims General MaintenanceReturns Procedure Technical Specifications PowerContact US World Wide