FIGURE 3
Connector
FIGURE 4
Connector
FIGURE 2
Step 4: Disconnect bulb wire from connector by holding the connector firmly with fingers then pulling bulb wire straight out as shown in Figure 2.
Step 5: Squeeze the wire retainer together and lift up as illustrated in Figure 3.
Step 6: Pull bulb straight out from the reflector mounting plate.
Step 7: To install new bulb, grasp the bulb from the metal end (DO NOT TOUCH THE GLASS PART) and insert into the reflector mounting plate. Align the slots in the bulb base with those in the reflector mounting plate.
Step 8: Replace wire retainer by squeezing ends together while pressing down. Release ends so that they catch on the reflector mounting plate.
Step 9: Reconnect the bulb wire to the connector as illustrated in Figure 4.
Step 10: To reassemble spotlight, align screw holes in the rear and front housings, then insert the rear housing into the front housing of the spotlight.
Step 11: Replace the two screws that were removed in Step 2. Do not overtighten screws.
Replacement bulbs and accessories may be purchased from The Brinkmann Corporation Consumer Sales Department by calling
3