To prevent serious injury
from accidental operation:
Turn the Power Switch to its off position and disconnect the Adapter Cord from its electrical supply source before performing any inspection, maintenance, or cleaning procedures.
Worklight Set Up
1.Always place the Worklight on a clean, dry, flat, level surface capable of supporting the weight of the Work- light.
2.The work area must be free of direct sunshine and high temperature.
3.Keep children and pets out of the work area.
4.Route the AC/DC Adapter Cord (17) and Cigarette Lighter Adapter Cord (16) along a safe route to reach the work area without creating a tripping hazard or exposing the Cords to pos- sible damage. The Cords must reach the work area with enough extra length to allow free movement while working.
General Operating Instructions
To Charge the Battery Pack Using the AC/DC Adapter:
1.To charge the Battery Pack (12) of the Worklight, open the Charging Socket Cover (11) on the tool and insert the AC/DC Adapter Cord (17) into the tool’s Charging Socket (7). Make sure the Power Switch (10) is in its “OFF” position throughout the
charging process. Then plug the AC/ DC Adapter into the nearest 120 volt, grounded, electrical outlet.
2.IMPORTANT: The initial charge time for the Battery Pack is 10 hours. Thereafter, the charge times are 6 hours. Do not overcharge the Bat- tery to avoid damage to the Battery and/or AC/DC Adapter.
3.The Battery Indicator Light on the Worklight will illuminate as follows:
•Battery needs charging: Right side LED illuminates RED.
•Battery is charging: Left side LED illuminates RED.
•Battery is fully charged: Left side LED illuminates GREEN.
4.When finished charging, unplug the
AC/DC Adapter from its electrical out- let. Then unplug the Cord from the Charging Input Port of the Worklight.
(See Figure A.)
POWER SWITCH (10)
CHARGING SOCKET COVER
(11)
AC/DC ADAPTER | FIGURE A |
CORD (17) |
|
OR |
|
CIGARETTE LIGHTER |
|
ADAPTER CORD |
|
(16) |
|
SKU 98113 | For technical questions, please call | Page 7 |