3.SETUP
AC Power
Fuse Replacement
This product has an
To determine the power requirements for this product (circuit breaker, power outlet, and wiring), use the current value listed on the label affixed to the product’s back panel, or refer to the product’s specifications chart. The listed current rating indicates the product’s average current draw under normal conditions.
Always connect this product to a protected circuit (circuit breaker or fuse), making sure that it has an appropriate electrical ground to avoid the risk of electrocution or fire.
Never connect this product to a rheostat (variable resistor) or dimmer circuit, even if the rheostat or dimmer channel serves only as a 0 to 100% switch.
Follow the instructions below to change the fuse, if necessary.
Disconnect this product from the power outlet before replacing the fuse.
1.Wedge the tip of a flat head screwdriver into the slot of the fuse holder and pry out of its housing.
2.Remove the blown fuse from its holder and replace with a fuse of the exact same type and rating.
3.Insert the fuse holder back into place, and reconnect power.
Installed fuse
(held by plastic clip)
Spare fuse holder (inside safety cap)
Safety cap
This product ships with no spare fuse. The safety cap does have room for a spare.
Always replace a blown fuse of the same type and rating.
Page 6 of 13 | MotionDrape™ LED User Manual (Rev. 05) |