Rechargeable 60 LED Work Light

INITIAL BATTERY CONNECTION INSTRUCTIONS / BATTERY REPLACEMENT INSTRUCTIONS

1. Remove screws from the bottom of the light with a small Phillips screwdriver.

2. Slowly pull the battery pack out from the light.

3. Disconnect the plug when replacing battery; go to step 4 for initial battery connection.

4. Connect the plug with the new battery pack.

5. Slowly insert the new battery pack into the light

6. Install the screws.

•Intelligent Charger - Prevents battery overload and burn-out

•Easy Battery Replacement System

•60 super bright LED 12000 MCD

•Single charge provides up to 3 hours of continuous use

•High light output with low energy consumption

•Minimal heat generated

•Unit uses 900 mAh replaceable Ni-MH batteries

•Designed with complete discharge protection with indicator light

•UL listed 120V (100-240V) AC 50/60Hz, 12V DC 400mAh main charger included

•Removable battery pack provides simple replacement

•Recessed charging jack and on/off switch provides protection from damage caused by dropping

•CE listed

RECHARGEABLE 60 LED WORK LIGHT

MADE IN CHINA

Page 3