Installing the Spark Guard and Eye Shield Mounting Brackets
Refer to Figure 2:
Parts needed:
2Spark Guard and Eye Shield Brackets assembled from previous page
41/4” x 3/8” Hex Cap Screws (E)
41/4" Flat Washers (F)
1.Install the left spark guard and mounting bracket (A) to the left wheel housing (M) with two 1/4” x 3/8” hex cap screws (E) and two 1/4" flat washers (F).
The spark guards (A1) should be adjusted to within 1/16" of the grinding wheel surface or other accessory being used.
2.Install the right spark guard and mounting bracket in the same manner.
Note: As the wheel wears down, the spark guards must be
Tool Rests
Refer to Figure 2:
Parts needed:
2Tool Rest Left (J) and Right (not shown)
45/16" x 3/4" Hex Cap Screws (C)
45/16" Flat Washers (D)
Note: There is a left and a right tool rest. Refer to Figure 1 to ensure that you install them correctly.
1.Install the left tool rest (J) by threading two 5/16" x 3/4" hex cap screws (C) through two 5/16" flat washers (D) and the tool rest (J) into the wheel housing (M).
The tool rests should be adjusted to within 1/16" of the grinding wheel or other accessories being used. As the wheel wears down, the tool rest must be
2.Install the right tool rest in the same manner.
Figure 2
To install eye shields (refer to Figure 2):
Insert two 3/16” x 3/8” pan head screws (H) through the mounting plate (A2), eye shield (C), and bracket plate (G) containing threaded mounting holes.
Tighten the screws (H).
Eye Shields
Refer to Figure 2.
Parts needed:
43/16” x 3/8” Pan Head Screws (H)
2Eye Shields (L)
2Eye Shield Bracket Plates (G)
The eye shields (L) are identical and will fit on either side of the grinder.
9
Mounting the Grinder
To prevent the grinder from moving during operation, it should be securely mounted to a work surface or grinder stand.
1.Align the mounting holes on the grinder with predrilled holes in a bench or grinder stand.
2.Insert bolts through the holes and tighten, using washers and nuts (not included).