Makita 9557HN, 9556HN, 9558HN specifications When Spacer is used When Spacer is not used

Page 6

P 6/ 8

Wiring diagram

[1] Connecting Lead Wires of Power Supply Cord with Switch

Connect the lead wires with Switch as illustrated in Fig. 12.

Fig. 12

[When Spacer is used]	[When Spacer is not used]
Power supply cord
Switch button
Switch
Spacer

[2]Wiring of Field Lead Wires in the Rear of Motor Housing

[2]-1. Rear End

Route Field lead wires as illustrated in Figs. 13 - 16.

Fig. 13

[Lead Wires of Field]

Lead wire (black)

Field

Lead wire (white)

[Motor Housing with Field] (view from Rear cover side)

Earth terminal on the lead wire (clear)
of Noise suppressor* has to be connected
to this portion.	Connect to Brush holder A.

Brush holder A

Lead wire (black)

Switch lever

Lead wire (white)

Lead wire (black)

						Connect to


						Switch terminals.
						Switch terminals.

Connect to Brush holder B.
Connect to Brush holder B.					Brush holder B
					Brush holder B

Spindle

*Some countries do not use noise suppressor.

Image 6

Contents Specification Optional accessoriesStandard equipment Repair Armature and Spiral Bevel GearDisassembling Spiral Bevel Gear 37 and Ball Bearing 6201DDW Switch lever SpindleRepair Armature and Small Spiral Bevel Gear AssemblingDisassembling/Assembling Shaft Lock Mechanism How to fit Retaining ring S-12 in place See FigRepair Spiral Bevel Gear 37 and Ball Bearing 6201DDW Tightening Tapping Screws That Fasten the FieldCircuit diagram When Spacer is used When Spacer is not used Right side view Make sure that Field lead wiresAre tight in Motor housing Bottom viewLeft side view Make sure that Field lead wires are tight in Motor housingTop Top view