Troubleshooting

Problem		Possible Causes		Likely Solutions
Tool will not start	1.	No power at outlet.	1.	Check power at outlet.
	2.	Cord not connected.	2.	Check that cord is plugged in.
	3.	Carbon Brushes may be worn or	3.	Inspect Carbon Brushes and replace if
		damaged.		necessary.
Tool operates	1. Carbon Brushes may be worn or		1.	Inspect Carbon Brushes and replace if
slowly or		damaged.		necessary.
erratically.	2.	Excess pressure applied to	2.	Decrease pressure, allow tool to do
		workpiece.		the work.
Tool does not	1. Disc accessory may be loose on		1.	Be sure disc accessory is of correct
grind, sand or		Spindle. Check tightness of Outer		dimension and Outer Flange Arbor Nut
brush effectively.		Flange Arbor Nut or threaded disc		is tight.
		accessory on Spindle.
	2.	Disc accessory may be damaged,	2.	Check condition and type of disc
		worn or wrong type for the		accessory. Use only proper type of
		material.		disc accessory in good condition.

Follow all safety precautions whenever diagnosing or servicing the tool. Disconnect power supply before service.

PLEASE READ THE FOLLOWING CAREFULLY

The manufacturer and/or distributor has provided the parts list and assembly diagram in this manual as a reference tool only. Neither the manufacturer or distributor makes any representation or warranty of any kind to the buyer that he or she is qualified to make any repairs to the product, or that he or she is qualified to replace any parts of the product. In fact, the manufacturer and/ or distributor expressly states that all repairs and parts replacements should be undertaken by certified and licensed technicians, and not by the buyer. The buyer assumes all risk and liability arising out of his or her repairs to the original product or replacement parts thereto, or arising out of his or her installation of replacement parts thereto.

SKU 97588

For technical questions, please call 1-800-444-3353.

Page 18