WARNING: AIR SUPPLY AND CONNECTIONS
•Do not use oxygen, combustible gases, or bottled gases as a power source for this tool as the tool may explode, possibly causing injury.
•Do not use supply sources which can potentially exceed
200 PSI (13.8bar) as tool may burst, possibly causing injury.
•The connector on the tool must not hold pressure
when air supply is disconnected. If a wrong fitting is used, the tool can remain charged with air after disconnecting and thus will be able to after the air line is disconnected possibly causing injury.
•Always disconnect air supply:
1)Before making adjustments;
2)When servicing the tool;
3)When tool is not in use;
4)When moving to a different work area, as accidental actuation may occur, possibly causing injury.
WARNING: ADDITIONAL SAFETY INSTRUCTIONS FOR GRINDERS
•Accessories must be rated for at least the speed recommended on the tool. Wheels and other accessories running over rated speed can fly apart and cause Injury.
Accessory ratings must be above listed minimum wheel speed for tool.
•Do not use saw blades or other toothed blades with this tool.
Serious injury may result.
•When starting tool with new or replacement wheel or other accessory, hold tool in
•Never start the tool with an operator or others in line with the wheel or accessory. If the wheel or accessory has an undetected flaw, it can burst in less than a minute.
•Avoid bouncing the wheel or subjecting it to rough handling
•Direct sparks away from operator, by standards or flammable materials.
•Disconnect tool from air supply when changing accessories or when not in use.
•Do not carry tool with throttle depressed. Do not disable Throttle Safety Lever. Do not tape or lock throttle in run position.
•Use only recommended air tool grinder accessories.
SAVE THESE INSTRUCTIONS
FOR FUTURE USE
English
9