Specifications
yt feSa
Setup - Before Use:
Electrical Rating | 120V~ / 60Hz / 11A | |
|
| |
Motor No Load Speed | 7800 RPM | |
|
| |
Max. Accessory Diameter | 7″ (178 mm) | |
Max. Accessory Thickness | 1/4" (6mm) | |
Arbor Hole Diameter | 7/8" | |
Using included adapter | ||
| ||
Spindle Thread | 5/8″ x 11 TPI |
etupS
no atierOp
ce enan Maint
Read the entire Important Safety Information section at the beginning of this manual including all text under subheadings therein before set up or use of this product.
To prevent serious injury from accidental operation:
Turn the Power Switch of the tool off and unplug the tool from its electrical outlet before assembling or making any adjustments to the tool.
Note: For additional information regarding the parts listed in the following pages, refer to the Assembly Diagram near the end of this manual.
Assembly
Installing the Wheel Guard
TO PREVENT SERIOUS INJURY: Do not operate this tool without the Wheel Guard properly installed.
Wheel | 1. | Loosen the Wheel Guard Nut. |
Guard | 2. | Slide the collar of the Wheel Guard |
Nut | ||
Collar | Wheel Guard | over the rim of the Gear Housing. |
| ||
| 3. | Rotate the Wheel Guard as needed to |
|
| shield you during the planned work. |
| 4. | Tighten the Wheel Guard Nut securely. |
Gear | 5. | Check the Wheel Guard to ensure it is firmly in place. |
Housing |
| Adjust if necessary before proceeding. |
Figure A
Page 12 | For technical questions, please call | Item 69454 |