Chicago Electric 69454 Cleaning, Maintenance, and Lubrication, Accessory Storage and Handling

Page 16

yt feSa

Maintenance and Servicing

Procedures not specifically explained in this manual must be performed only by a qualified technician.

To prevent serious injury from accidental operation:

Turn the Power Switch of the tool off and unplug the tool from its electrical outlet before performing any inspection, maintenance, or cleaning procedures.

To prevent serious injury from tool failure:

Do not use damaged equipment. If abnormal noise or vibration occurs, have the problem corrected before further use.

Cleaning, Maintenance, and Lubrication

etupS

1.BEFORE EACH USE, inspect the general condition of the tool. Check for:

loose hardware,

misalignment or binding of moving parts,

cracked or broken parts,

damaged electrical wiring, and

any other condition that may affect its safe operation.

2.After Use, wipe external surfaces of the tool with clean cloth.

3.Periodically blow dust and grit out of the motor vents using dry compressed air. Wear ANSI‑approved safety goggles and NIOSH‑approved

breathing protection while doing this.

4.WARNING! If the supply cord of this power tool is damaged, it must be replaced only by a qualified service technician.

no atierOp

ce enan Maint

Accessory Storage and Handling

1. Handle accessories carefully to prevent

2. Store accessories in shelves, racks, boxes, or

dropping or bumping. Do not use wheels

drawers. Storage area must be kept dry, and above

that have been dropped or bumped.

freezing. Any grinding or cut-off wheels exposed to

 

humidity or freezing temperatures must not be used.

Page 16

For technical questions, please call 1-800-444-3353.

Item 69454

Image 16
Contents Angle grinder General Power Tool Safety Warnings Table of ContentsWork area safety Electrical safety Personal safetySafety SetupPower tool use and care ServiceYt feSa AtierOp Ce enan MaintSafety Setup Operation Maintenance Yt feSa EtupS No atierOp Ce enan Maint Safety Setup Kickback and Related WarningsYt feSa EtupS No atierOp Ce enan MaintVibration Safety Double Insulated Tools Tools with Two Prong Plugs Grounded Tools Tools with Three Prong PlugsGrounding Extension Cords Symbology25′ 50′ 75′ Assembly Installing the Wheel Guard SpecificationsSetup Before Use EtupS No atierOp Ce enan MaintInstalling the Auxiliary Handle FunctionsInstalling a Non-threaded Grinding Wheel Tool Set UpOperating Instructions Installing a Threaded Accessory Workpiece and Work Area Set UpGeneral Operating Instructions Accessory Storage and Handling Cleaning, Maintenance, and LubricationMaintenance and Servicing Troubleshooting Problem Possible Causes Likely SolutionsParts List Parts List and DiagramPart Description Qty Part DescriptionAssembly Diagram Limited 90 Day Warranty