Specifications
Electrical Input | 120 V~ / 60 Hz / .5 A (No Load) |
Motor Speed | 15,000 RPM (No Load) |
Flexible Shaft | 38” |
Chuck Capacity | 5/32” |
Unpacking
When unpacking, make sure that the item is intact and undamaged. If any parts are missing or broken, please call Harbor Freight Tools at
Operating Instructions
Read the entire Important Safety Information section at the beginning of this manual including all text under subheadings therein before set up or use of this product.
Tool Set Up
To prevent serious injury
from accidental operation:
Turn the Power Switch of the tool off and unplug the tool from its electrical outlet before adjusting tool or installing accessories.
1.Before operating, find a suitable spot in the work area to attach the Holder
(1)and the Hanger (4). Drive two
(2)screws (not included) through the Electric Rings and through the Holder. Attach the Hanger to the Motor Housing
(7)with the two (2) Screws (6).
2.Inspect the Flexible Shaft (21) and make certain that it is securely connected to the Motor Housing Unit (7). Do not use the Shaft at an angle greater than 90°.
Kinks or crimps in the shaft will result in inefficient tool performance.
3.Attach the Foot Control. Insert the Plug (29) into the Female Plug (28) which comes off of the Foot Control (27). Insert the Power Plug (26) into the receptacle.
4.Install a bit by using the Chuck Key (25) to loosen the Drill Chuck (24). Insert bit and then tighten the Drill Chuck by using the Chuck Key.
Work Piece and Work Area Set Up
1.Designate a work area that is clean and
2.Route the power cord along a safe route to reach the work area without creating a tripping hazard or exposing the power cord to possible damage. The power cord must reach the work area with enough extra length to allow free movement while working.
3.Secure loose work pieces using a vise or clamps (not included) to prevent movement while working.
4.There must not be objects, such as utility lines, nearby that will present a hazard while working.
REV 06g, 08l, 09e
Page 8 | For technical questions, please call | SKU 40432 |