Assembly and Operation Instructions (continued)
9.With a firm grip on the Die Grinder, lightly apply the Grinding Drum to the workpiece, slowly and steadily moving the Grinding Drum to the right and left until you have achieved the desired appearance (finish) on the workpiece.
10.Once the work is completed, release the hand pressure on the Lever (14). The Lever Pin (15) will automatically return to its locked position to prevent the Lever from ac- cidentally being activated.
11.Turn off the air compressor. Trip the Lever Pin (15) with your finger and slowly squeeze the Trigger (14) to release any remaining air pressure from the Die Grinder. Then dis- connect the air hose from the tool.
12.Remove the Grinding Drum from the Die Grinder. Then store the tool in a clean and dry location out of the reach of children.
Inspection, Maintenance, and Cleaning
1.Warning: Always make sure the Lever (14) is in its “OFF” position and disconnect the Die Grinder from its compressed air supply before performing any inspection, adjustments, maintenance, or cleaning.
2.Before each use, inspect the general condition of the Die Grinder. Check for loose screws, misalignment or binding of moving parts, cracked or broken parts, damaged air hose, and any other condition that may affect its safe operation. If abnormal noise or vibration occurs, have the problem corrected before further use. Never use damaged equipment.
3.Daily: With a clean cloth, remove all dirt, oil, and grease from the Die Grinder. If neces- sary, you may use a mild detergent. Do not use solvents, as damage to the Die Grinder may occur. Do not immerse the Die Grinder in any liquids.
SKU 95029 | For technical questions, please call | Page |