20.Industrial applications must follow OSHA requirements.
Warning: Some dust created by power sanding, sawing, grinding, drilling and other construction activities contain chemicals known (to the State of California) to cause cancer, birth defects or other reproductive harm. Some examples of these chemicals are: lead from
The warnings, cautions, and instructions discussed in this instruction manual cannot cover all possible conditions and situations that may occur. It must be understood by the operator that common sense and caution are factors which cannot be built into this product, but must be supplied by the operator.
Unpacking
When unpacking, check to make sure the parts listed on page 7 are included. If any parts are missing or broken, please call Harbor Freight Tools at the number on the cover of this manual as soon as possible.
Assembly and Operating Instructions
To Attach a Quick Connector:
1.It is recommended that prior to use, you attach a Quick Connector (not included) into the Die Grinder’s Air Inlet (13). To do so, wrap approximately 3” of pipe thread sealer tape (not included) around the male threads of a Quick Connector. Then firmly tighten the Quick Connector into the Air Inlet. (See Figure A.)
Figure A
Quick Connector (not included)
Air Inlet (13)
RECOMMENDED
Air Hose (not included) | Quick Connector to Oiler | COMPRESSED | ||
AIR SYSTEM | ||||
|
| (not included) | ||
|
| |||
|
|
|
| |
|
| Regulator |
|
|
|
| |
Quick Coupler | (not included) |
|
|
|
| ||
(not included) |
|
|
|
|
|
| |
|
|
|
| Air |
| Hose | Compressor |
|
|
|
|
| |||
|
|
|
|
| |||
|
|
|
|
| |||
|
|
|
| (not included) | |||
|
|
|
|
|
|
| (not included) |
|
|
| Filter (not included) |
| |||
Oiler (not included) |
| ||||||
SKU 95029 | For technical questions, please call | Page |