Harbor Freight Tools 37822 Instructions for putting into use, Assembly, Installing Tool Rests

Page 9

Instructions for putting into use

Read the entire Important Safety Information section at the beginning of this manual including all text under subheadings therein before set up or use of this product.

To prevent serious injury

from accidental operation:

Turn the tool off and unplug it before assembling or making any adjustments to the tool.

Note: For additional information regarding the parts listed in the following pages, refer to the Assembly Diagram near the end of this manual.

Assembly

1.Installing Tool Rests -

a. Turn the Grinder off and unplug it.

shown in Figure 1. Use bolts and washers to secure them in place as shown in Figure 1.

Note: There is a left and a right tool rest. Refer to Figure 1 to be certain that you install them correctly.

c. The tool rests should be adjusted to within 1/16” of the grinding wheel. To adjust this distance, move Adjust- able Rests (22 and 35) by loosening bolts and moving them to the proper position.

2.Installing Spark Guards -

Figure 2

a. Select spark guards (17 and 18), washer and bolt. Install the right spark guard to the wheel guard as shown in Figure 2.

b. Adjust the spark guard to within 1/16” of the grinding wheel. Repeat for left side.

Note: There is a left and right spark guard. Refer to Figure 2 to be certain that you install them correctly.

Figure 1

b. Install adjustable rests (22 and 35) to the wheel guards (7 and 27) as

REV 01b

Bench Grinder

For technical questions, please call 1-800-444-3353.

Page 9

Image 9
Contents Distributed exclusively by Harbor Freight Tools For technical questions or replacement parts, please callContents General Tool Safety Warnings Save This ManualSave all warnings and instructions for future reference Table a 25’ 50’ 100’ 150’Grounding Instructions With Three Prong Plugs125 V~ 3-Prong Plug and Outlet Do not operate with ANY guard disabled, damaged, or removed Grinder Safety WarningsVibration Safety Unpacking SpecificationsAll Models ModelInstalling Tool Rests AssemblyInstalling Spark Guards Instructions for putting into useInstalling Eye Shield to Grinder Installing Bracket to Eye ShieldOperating Instructions Work Piece and Work Area Set UpGeneral Operating Instructions Sharpening KnivesCleaning, Maintenance, Lubrication Maintenance ServicingWheel Replacement Bulb ReplacementProblem Possible Causes Likely Solutions TroubleshootingPart Description Parts ListAssembly Diagram Limited 1 year / 90 Day warranty