Harbor Freight Tools 45707 Specifications Table, Safety Warnings and Precautions

Page 2

SPECIFICATIONS TABLE

Electrical Requirements

120V / 60 Hz / 1/3HP / 3,600 RPM Motor

Maximum Stock Capacity

3/4”

Maximum Grinding Diameter

1”

Taper Angle

0-180 Degrees

Relief Angle

0-45 Degrees

Negative Angle

0-26 Degrees

Grinding Wheel Size

4” Diameter x 2” Deep x 3/4” Thick

Light Source

Built-In Lamp – 12V, 35 Watts

Weight

92.5 lb.

Note: Additional operating instructions and user information is available in the backup

Operating Handbook included with this product. Please read and understand this

instruction manual and the backup Operating Handbook before using the Univer-

sal Cutter/Grinder.

SAVE THIS MANUAL

You will need this manual for the safety warnings and precautions, operating and maintenance procedures, parts list and diagram. Keep your invoice with this manual. Write the invoice number on the inside of the front cover. Keep this manual and invoice in a safe and dry place for future reference.

SAFETY WARNINGS AND PRECAUTIONS

1.KEEP WORK AREA CLEAN AND DRY. Cluttered, damp or wet work areas invite injuries.

2.KEEP CHILDREN AWAY FROM WORK AREA. Do not allow children to handle this product.

3.STORE IDLE EQUIPMENT. When not in use, tools and equipment should be stored in a dry location to inhibit rust. Always lock up tools and equipment and keep out of reach of children.

4.DO NOT USE THIS PRODUCT IF UNDER THE INFLUENCE OF ALCOHOL OR DRUGS. Read warning labels on prescriptions to determine if your judgement or reflexes are impaired while taking drugs. If there is any doubt, do not attempt to use this tool.

5.USE EYE AND HEARING PROTECTION. Wear ANSI approved safety impact eye glasses with an ANSI approved full face mask. Also, wear ANSI approved hearing protectors when working with this product. ANSI approved safety impact eye glasses, full face mask, and hearing protectors are available from Harbor Freight Tools.

Rev 02b

SKU 45707

For technical questions, please call 1-800-444-3353.

Page

Image 2
Contents For technical questions or replacement parts, please call Universal Cutter GrinderSave this Manual Specifications TableSafety Warnings and Precautions For technical questions, please callSpecific Product Warnings and Precautions Industrial Applications Must Follow Osha RequirementsKeep ALL Guards in Place and in Working Order Product Overview Diagrams A, B, C, and FUnpacking Parts Components To USE the Tool Cutter FeatureAssy. Diagram F Part FunctionDressing the Grinding Wheel Assy. Diagram a Assy. Diagrams A, and FCleaning and Maintenance Please Read the Following CarefullyPart Description Parts List aAssembly Diagram a SKU For technical questions, please call Parts List BAssembly Diagram B Parts List C Assembly Diagram CParts List D Assembly Diagram DParts List E Assembly Diagram EParts List F Assembly Diagram FLimited 90 DAY Warranty