EYE SHIELD (#26) | EYE SHIELD (#26) | ||
| PRESSURE PLATE | PRESSURE PLATE | |
(#50) | (#50) |
| |
| LEFT EYE SHIELD | RIGHT EYE SHIELD | |
| MOUNTING ROD | MOUNTING ROD | |
| (#49) | (#33) |
|
|
|
|
|
SCREW | SCREW | ||
(#55) | (#55) | ||
FIGURE G
2.There are two 11/32” diameter mounting holes located on the Base (part #15) of the Bench Grinder. (See Figure H.)
3.Temporarily set the Bench Grinder in the desired location on the workbench. Use the two 11/32” diameter mounting holes on the Bench Grinder as templates to mark where two 11/32” diameter holes will be drilled through the top of the work- bench. Once marked, remove the Bench Grinder.
4.Where previously marked, drill the two 11/32” holes through the top of the work- bench.
5.Set the Bench Grinder back on the workbench, and align the two mounting holes on the Bench Grinder with the two previously drilled holes in the workbench. Then secure the Bench Grinder to the workbench, using two 11/32” diameter Bolts of appropriate length, two Lock Washers, and two Nuts (none included).
EYE SHIELD |
|
|
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
| ||||
(#26) |
|
|
|
|
|
|
|
|
|
| EYE SHIELD | |
|
|
|
|
|
|
|
|
|
| |||
|
|
|
|
|
|
|
|
|
|
| ||
|
|
|
|
| (#26) | |||||||
GRINDING WHEEL |
|
|
|
| GRINDING WHEEL | |||||||
|
|
|
| |||||||||
(#64) |
|
|
|
|
|
| ||||||
|
|
| (#64) | |||||||||
|
|
|
|
| ||||||||
LEFT |
|
|
|
|
|
|
|
|
|
|
| RIGHT |
|
|
|
|
|
|
|
|
|
|
| ||
TOOL REST |
|
|
|
|
|
|
| |||||
|
|
|
|
|
|
| ||||||
|
|
|
|
|
| TOOL REST | ||||||
(#28) |
|
|
|
|
|
|
|
|
|
| ||
|
|
|
| (#32) | ||||||||
|
|
|
|
| ||||||||
11/32” MOUNTING HOLE 
11/32” MOUNTING HOLE
POWER SWITCH (#3)
FIGURE H
SKU 90003 | PAGE 13 |