SPECIFIC SAFETY RULES
1.Maintain labels and nameplates on the Grinder. These carry important information. If unreadable or missing, contact Harbor Freight Tools for a replacement.
2.Always grip the Grinder firmly when operating the tool.
3.Always use accessories that have an RPM rating of at least 21,000 and a 1/4” diameter shank. Using accessories not rated to meet the RPM capacity of this tool or with an improperly sized shank can result in damaged accessories, personal injury, and/or property damage.
4.Use clean, dry, regulated, compressed air at 90 PSI. Do not exceed the recommended 90 PSI. Never use oxygen, carbon dioxide, combustible gases, or any other bottled gas as a power source for this tool.
5.Always disconnect the Grinder from its compressed air supply source, and squeeze theTrigger (4) to verify that the tool cannot operate before performing any maintenance or services.
6.Before using the Grinder, make sure that any accessories are properly attached to the tool. Make sure to wrench tighten the collet before use.
7.Check accessories for any signs of excessive wear or damage before use.
DO NOT USE DAMAGED ACCESSORIES.
8.Accessories may become hot while grinding. Allow accessories to completely stop and cool before touching.
9.Allow the accessory to move at full speed before feeding them into the work- piece. Do not force the accessory into the workpiece when grinding. Apply moder- ate pressure, allowing it to grind without being forced. When turning off the Grinder, allow the accessory to stop on its own; do not press against it to stop it.
10.Industrial applications must follow OSHA requirements.
11.WARNING! The brass components of this product contain lead, a chemical known to the State of California to cause birth defects (or other reproductive harm). (California Health & Safety code § 25249.5, et seq.)
12.WARNING! The warnings, precautions, and instructions discussed in this manual cannot cover all possible conditions and situations that may occur. The operator must understand that common sense and caution are factors which cannot be built into this product, but must be supplied by the operator.
SKU 33171 | For technical questions, please call | Page 5 |