ACCESSORY INSTALLATION
1.Make sure the air supply is disconnected first. Insert the Collet (24) into the Collet Nut (25). Then, thread the Collet Nut onto the Spindle (33) a few turns.
(See Figure A.)
COLLET (24)
SAFETY
|
| COLLET NUT (25) |
|
|
| LEVER (39) | ||
|
|
|
|
| ||||
|
|
|
|
|
|
|
| |
FIGURE A | COLLET NUT (25) |
|
|
|
| SPINDLE (33) | ||
|
|
|
| |||||
|
|
|
|
| COLLET (24) | |||
|
|
|
| |||||
|
|
|
|
|
| |||
|
|
|
|
|
| |||
|
|
|
|
|
|
|
| (NOT SHOWN) |
2.Insert the shank of the accessory upward into the flared end of the Collet (24).
3.Place the small end of the Spanner (27) on the flats of the Spindle (33). Place the large end of the other Spanner (27) on the flats of the Collet Nut (25). Then, tighten the Collet Nut to secure the accessory in place.
(See Figure B.)
FIGURE B
TIGHTEN
SPANNER
(27)
SPANNER
(27)
SKU 33171 | For technical questions, please call | Page 7 |