Harbor Freight Tools 45725 operating instructions Unpacking, Assembly, REV 05/02

Page 4

Note: Performance of this tool (if powered by line voltage) may vary depending on variations in local line voltage. Extension cord usage may also affect tool performance.

Warning:The warnings, cautions, and instructions discussed in this instruction manual cannot cover all possible conditions and situations that may occur. It must be under- stood by the operator that common sense and caution are factors which cannot be built into this product, but must be supplied by the operator.

WARNING: Some dust created by power sanding, sawing, grinding, drilling, and other construction activites, contain chemicals known [to the State of California] to cause cancer, birth defects or other reproductive harm. some examples of these chemicals are:

*Lead from lead-based paints

*Crystalline cilica from bricks and cement or other masonry products

*Arsenic and chromium from chemically treated lumber

Your risk from these exposures varies, depending on how often you do this type of work. To reduce your exposure to these chemicals: work in a well ventilated area, and work with approved safety equipment, such as those dust masks that are specially designed to filter out microscopic particles.

(California Health & Safety Code 25249.5, et seq. )

Note: This tool comes equipped with a 220 V power cord with no plug. Have a plug installed by a licensed electrician. This tool will only work on a 220 V outlet. If you need one installed, use a licensed electrician.

Unpacking

When unpacking, check to make sure parts listed on page 8 are included. If any parts are missing or broken, please call Harbor Freight Tools at the number on the cover of this manual as soon as possible.

Warning! Operation of equipment in close proximity to a heart pacemaker could cause interference or failure of the pacemaker.

Assembly

1.Have a licensed electrician attach a 220 Volt plug to the power cord.

2.Stick a PSA (Pressure Sensitive Adhesive) backed 20 inch sanding disc on the metal sanding / grinding disc.

SKU 45725

Page 4

REV 05/02

Image 4
Contents For technical questions and replacement parts, please call Inch Disc Sander / GrinderSafety Warnings and Precautions SpecificationsRead all instructions before using this tool REV05/02 Unpacking AssemblyREV 05/02 Work Table Adjustment OperationRunning the Sander / Grinder Maintenance Parts List Please Read the Following CarefullyAssembly Drawing