Operation (continued)
6.When you finish sanding or grinding, turn the Neutral / Direction Switch to neutral and wait until the wheel comes to a complete stop. Turn off the On / Off Switch. See Figure 1.
7.If you wish to switch rotation direction without turning off the machine, turn the
Neutral / Direction Switch to neutral and wait until the wheel comes to a complete stop, and then turn switch to the opposite direction.
Maintenance
Warning! Make sure your Sander / Grinder is unplugged before attempting any maintenance.
1.Remove your vacuum hose (not included) from the vacuum port and clean out port.
2.Clean the surface of the Sander / Grinder with a clean cloth or soft dry brush.
3.Check all nuts and bolts for tightness. Tighten if necessary.
4.Check sanding disk for tears or frays. Replace if necessary.
5.Clean debris from 3/4” miter slot.
SKU 45725 | Page 7 |