Safety Instructions For Power Tools
10.WEAR PROPER APPAREL. Do not wear loose clothing, gloves, neck- ties, rings, bracelets, or other jewel- ry which may get caught in moving parts.
11.ALWAYS USE SAFETY GLASSES. Also use face or dust mask if cutting operation is dusty. Everyday eye- glasses only have impact resistant lenses, they are NOT safety glass- es.
12.WEAR APPROVED HEARING PROTECTION.
13.SECURE WORK. Use clamps or a vise to hold work when practical. It is safer than using your hand and frees both hands to operate tool.
14.DO NOT OVERREACH. Keep prop- er footing and balance at all times.
15.MAINTAIN TOOLS WITH CARE. Keep tools sharp and clean for best and safest performance. Follow instructions for lubricating and changing accessories.
16.REDUCE THE RISK OF UNINTEN- TIONAL STARTING. Make sure switch is in off position before plug- ging in.
17.DISCONNECT TOOLS before ser- vicing and changing accessories.
18.USE THE RECOMMENDED
ACCESSORIES. Consult the owner’s manual for recommended accessories. The use of improper accessories may cause risk of injury.
19.CHECK DAMAGED PARTS. Before further use of the tool, a guard or other part that is damaged should be carefully checked to determine that it will operate properly and perform its intended function. Check for align- ment of moving parts, binding of moving parts, breakage of parts, mounting, and any other conditions that may affect its operation. A guard or other part that is damaged should be properly repaired or replaced.
20.NEVER ALLOW UNTRAINED USERS TO RUN THIS TOOL WHILE UNSUPERVISED.
21.IF YOU ARE UNSURE OF THE INTENDED OPERATION, STOP USING THE TOOL.
22.DO NOT BEND SHAFT MORE THAN 90 DEGREES. Make sure the Flexible Shaft (P9928021) is not bent more than a 90 degree angle. If the Flexible Shaft is kinked or crimped, it could cause inefficient grinder operation and create a safe- ty hazard. Note: Performance of the Flexible Shaft Grinder may vary depending on local line voltage or use of an extension cord.
G9928 Flex Shaft Grinder |