MAINTENANCE
!
Disconnect power to the machine when performing any maintenance, assembly or adjustments. Failure to do this may result in serious person- al injury.
CARBON BRUSH REPLACEMENT
Normal Carbon Brush life is
1.Use a small screwdriver and remove the Carbon Brushes from the sides of the Motor Housing. Be careful when removing the brushes, as the brushes are
2.If the brush is not broken and is dirty, remove the dirt using a pencil eraser. Gently rub with the eraser until all of the dirt has been removed. Remove all eraser dust so it will not interfere with the machine.
3.Reinstall the brushes and gently tight- en with the screwdriver.
G9928 Flex Shaft Grinder
LUBRICATING FLEX SHAFT
The Flex Shaft and Flex Shaft Housing should be lubricated after every 8 hours of use. A small amount of light lithium lubri- cant or machine oil applied to the length of the Flex Shaft is all that is needed. Too much lubricant can become messy and possibly get on your workpiece. Do not use automotive grease as it is too vis- cous.
REPLACEMENT ACCESSORIES
Should you need to order replacement parts for your Model G9928, please refer to the following parts diagram and list.
(1, 2, 3)
4
5
6
|
| 7 |
|
|
|
Ref | Part # | Description |
|
|
|
01 | P9928022 | CHUCK HOUSING |
02 | P9928023 | BEARING 608Z |
|
|
|
03 | P9928024 | CHUCK |
|
|
|
04 | P9928001 | HANGER |
05 | P9928025 | CHUCK KEY |
|
|
|
06 | P9928027 | FOOT CONTROL |
|
|
|
07 | P9928021 | FLEX SHAFT |
08 | P9928008 | CARBON BRUSH (NOT SHOWN) |
|
|
|
|
|