Grizzly G0596-99 InventoryMounting, Eye Shields, Box Qty, When locating your grinder, remember

InventoryMounting

After all the parts have been removed from the box you should have the following items:

Box 1:		Qty
A.	Grinder	1
B.	Wrench 38mm (G0596/G0597)	1
C.	Wrench 50mm (G0598/G0599)	1

NOTICE

Some hardware/fasteners on the inventory list may arrive pre-installed on the machine. Check these locations before assuming that any items from the inventory list are miss- ing.

Eye Shields

The eye shields on the Model G0596-99 may come pre-mounted from the factory. If they do not, attach them at this time with the two Phillips head screws provided.

Light Switch Mounting Screws

Figure 3. Eye shield.

DO NOT operate this grinder without the eye shields or wheel guards in place. Failure to properly use these safety devices could lead to serious injury!

-10-

Mount the grinder on the optional H7834 stand (see Page 17), or a workbench that is sturdy enough to hold the weight of the machine and any downward pressure that may be applied dur- ing operation.

The stand or workbench should be level, rigid, and attached to the floor, so it will not move dur- ing operation.

For proper safety, drill holes in your workbench and secure the grinder with hex bolts, washers, and hex nuts, or with lag screws and flat wash- ers. (Mounting hardware is not provided due to the many possible set ups and workbench thick- nesses.)

When locating your grinder, remember:

•You will need room for potentially large workpieces.

•Maintain easy access to dust ports for attach- ing dust collection system.

•Grinding without dust collection system spreads dust in the immediate vicinity of the grinder.

•Grinding creates flying sparks that MUST be out of reach of any flammables.

•You will need a lot of light around the grinding wheel in addition to the lighted eye shields.

Model G0596-99 (Mfg. since 3/06)