Chapter 4 Basic Wireless Device Configuration
Starting a Wireless Configuration Session
| Command |
| Purpose |
|
|
| |
Step 4 | interface vlan1 | Specifies the virtual LAN interface for data | |
|
|
| communication on the internal Gigabit Ethernet 0 |
| Example: |
| (GE0) port to other interfaces. |
|
| • All the switch ports inherit the default vlan1 | |
| |||
|
|
| interface on the Cisco 880 Series ISR. |
|
|
| |
Step 5 | ip address subnet mask | Specifies the interface IP address and subnet mask. | |
| Example: |
|
|
|
| ||
| 10.10.0.30 | 255.255.255.0 |
|
|
|
|
|
Step 6 | exit |
| Exits the interface configuration mode. |
| Example: |
|
|
|
| ||
| router(config)# |
| |
|
|
|
|
Step 7 | exit |
| Exits the global configuration mode. |
| Example: |
|
|
| router(config)# exit |
| |
| router# |
|
|
|
|
| |
Step 8 |
| Opens the connection between the wireless device and | |
|
|
| the router’s console. |
| Example: |
|
|
| router# |
| |
| session |
|
|
| Trying 10.21.0.20, 2002 ... Open |
| |
| ap> |
|
|
|
|
|
|
Tip If you want to create a Cisco IOS software alias for the console to session into the wireless device, enter the alias exec dot11radio
Closing the Session
To close the session between the wireless device and the router’s console, perform the following steps.
Wireless Device
1.Control-Shift-6 x Router
1.disconnect
2.Press Enter
Cisco 880 Series Integrated Services Router Software Configuration Guide
|
| ||
|
|