Cisco Systems Cisco 1712, Cisco 1711 manual Assembling Stacking Clip and Fastener

Page 16

Chapter 2 Installation

Optional Installation Steps

Figure 2-8 Assembling Stacking Clip and Fastener

Push plastic fastener

through small hole at the end of the stacking clip.

H11542

After assembling the clip and fastener, follow these steps to stack the router with another device:

Step 1 Place the clip on top of the lower device, as shown in Figure 2-9 on page 2-17. Slide the clip forward so that the front tabs slide into the vent slots. Make sure that the rear hooks fit over the edge of the lower device.

	Cisco 1711 and Cisco 1712 Security Access Routers Hardware Installation Guide
2-16	OL-4050-02

Image 16

Contents Installation Before Installing the RouterConnecting the Router to Your Local Network Installation Connecting the Router to Your Local Network Connecting the Router to the Local Network 10/100 Ethernet portConnecting the Router to Your Service Provider’s Equipment Straight-through Ethernet cable Cable modem/DSL hubConnecting Networked Devices to the Router’s Switch Ports RJ-45Connecting Power to the Router Installation Connecting Power to the Router Connecting the Power Supply Verifying Your Installation Optional Installation StepsConnecting a PC to the Router’s Console Port Connecting a Modem on the AUX Port Blue console cableConsole port To PC or terminalAUX port RJ-45 Modem Console cable DB-9-to-DB-25 adapterWall-Mounting Wall-Mount Brackets-Bottom of RouterStacking the Router Assembling Stacking Clip and Fastener Stacking the Router Unstacking the Router CiscoInstallation Optional Installation Steps OL-4050-02