Craftsman 315.175341 To Adjust Depth of CUT for Fixed Base Routers, Locking ARM, Point Ring

Page 14

TO ADJUST DEPTH OF CUT FOR FIXED BASE ROUTERS

See Figures 12, 13, and 14.

Follow these steps to adjust depth of cut for fixed base routers.

1, Unplug the router,

,_ WARNING: Failure to unplug the tool could result in sedous injury due to accidental starting.

2.Place the router on a flat surface.

3.Loosen the lockingarm.

4.Turn the depth adjustment ring counterclockwise until the tip of the cutter touchesthe flat surface.

5.Turn the depth indicator ring until the zero lines up

LOCKING

ARM

Fig. 12

with the indicator point on the base.

6.Position the router so that the cutter can extend below the subbase for desired depth of cut.

7.Turn the depth adjustment ring to obtain the desired depth of cut.

POINT IN__

RING

Fig. 13

8.Tighten the locking arm securely.

Note: To adjust the depth of cut when the router is mounted to a router table, turn the depth adjustment ring untilthe cutter reaches the desired depth of cut.

Fig, 14

Image 14

Contents Router Full ONE Year Warranty on CRRFT$1vlRH Router Tool USE and Care Electrical SafetyWork Area Additional Safety Rules ServiceWhen servicing a tool, use only identical replace Symbol DESIGNATION/EXPLANATIONService Symbol MeaningExtension Cords Double InsulationElectrical Connection 100Switch Motor Housing Goldspindle Lockbutton Product SpecificationsSwitch Know Your RouterRouter Motor Wrench OperatorsManual Carefully remove the tool and the accessoriesfrom the boxPacking List To Remove the Fixed or D-HANDLE Base Unplug the routerDepth Adjustment Ring To Switch from Plunge Base to Fixed Base or D-HANDLE BaseTo Install the Fixed or D-HANDLE Base Indicator ArrowREMOVING/INSERTING cunERS Causing serious personal injuryAdjusting Depth of CUT To remove the cutter Remove the cutter from the colletCutter Stop Plunge Lock BAR Lever KnobLock the plunge lock lever Point Ring To Adjust Depth of CUT for Fixed Base RoutersLocking ARM Operating the Router See Figures 16Feedguide Feeding the RouterRotation Rotation FeedRate of Feed Feeding Too Slow See FigurePass Depth of CUT2ND 1ST CUi-rERS Adjusting Locking ARM TensionGeneral LubricationPanel BIT Straighi COMBI-VEININGI Core Straight Combi HingeNation BIT BOX Face Nation Mortising Cutter BIT BevelPage Seenote Craftsman Router Motor Model Number671457001 See Back page for Parts Ordering InstructionsKey Part Description Qty 690141001 Your Home Call anytime, day or night U.SA and Canada