Operating Instructions
Read the entire Important Safety Information section at the beginning of this manual including all text under subheadings therein before set up or use of this product.
Tool Set Up
To prevent serious injury
from accidental operation:
Turn the Power Switch of the tool off and unplug the tool from its electrical outlet before preparing for
place. Keep the Spindle Lock Button depressed through step 6.
4.Use the Spanner Wrench (51) to loosen the Collet Nut (50).
5.Insert the bit all the way into the Collet. CAUTION! Bits are sharp,
Handle with care.
6.Securely tighten Collet Nut.
7.Release the Spindle Lock Button.
8.Pull up the Lock Lever to free the shaft.
9.Replace the Chip Shield.
Cutting Depth Adjustment
operation.
Installing Bits
Spindle Lock Button (46) Spindle
Chip
Shield 
Depth
Stop
Bar (30)
Depth
Adjusting 
Bolt (29)
Depth
Stop
Turret
Depth of Cut
(70)
Collet Nut (50)
Figure 2
1.Unthread the Screw (85) holding the Chip Shield (70) in place and remove the Chip Shield.
2.Lock the Plunge Lock Lever (32) in place to keep the shaft stationary.
3.Depress the Spindle Lock Button (46) and rotate the Spindle until it locks in
(67)Screw
(85)
Figure 3
The depth of cut is equal to the dis- tance between the lower end of the Depth Adjusting Bolt (29) and the section of the Depth Stop Turret (67) directly below the Depth Stop Bar (30). First, install the bit you will use for the cut, then adjust the Router as follows to set up the desired cutting depth.
SKU 67119 | For technical questions, please call | Page 12 |