1.Loosen the Thumb Screw so that the Depth Stop Bar (30) can slide freely.
2.Rotate the Adjusting Knob (26) until the Depth Adjusting Bolt (29) pro- trudes about 1/4” from the Depth Stop Bar.
3.Rotate the Depth Stop Bar to the left so that the indexing mark along the top of the Bar is visible from under the Pointer (28).
4.Hold the Bar and rotate the Adjust- ing Knob until the Zero mark along the base of the adjusting Knob aligns with the indexing line.
5.Rotate the Depth Stop Turret (67) to the lowest setting.
6.Loosen the Plunge Lock Lever (32).
7.Lower the Router body until the bit just touches the workpiece.
8.Tighten the Plunge Lock Lever.
9.Use one of the following two ways to adjust the router depth:
Adjusting | Increment Guide |
Knob (26) |
|
Depth |
|
Stop | Pointer |
Bar | (28) |
(30) |
|
Thumb Screw
Figure 4
•Position the Depth Adjusting Bolt (29), so that it is touching the Depth
Stop Turret (67). Slide the Pointer
(28)to zero on the Increment Guide, then raise the Depth Stop Bar to the desired height using the Pointer and the Increment Guide. Tighten the Thumb Screw to hold the Stop Bar in place.
•Or, using a piece of wood the thick- ness of the desired cut, place the piece of wood on the Lowest level of the Depth Stop Turret (67). Adjust the Depth Stop Bar (29) so that the Depth Stop Bolt (29) rests on the piece of wood and tighten in place with the Thumb Screw.
Note: For marginal depth adjustments, raise the Depth Adjusting Bolt (29) (located inside the Depth Stop Bar) in fine increments by turning the Adjusting Knob (26) to set the exact desired depth of cut. Use the Pointer
(28) along with the increment guide to help make the adjustment.
10.Loosen the Plunge Lock Lever and allow the router to return to its original position.
Edge Guide
Thumb Screws (81)
Fence |
|
| Bars |
|
| ||
Figure 5 | Edge |
| Guide |
| |||
To attach the Edge Guide when mak- ing straight cuts:
a. Loosen the Thumb Screws (81).
SKU 67119 | For technical questions, please call | Page 13 |