SELECTION GUIDE FOR TABLE INSERTS
This machine is supplied with 5 spindles, and four table inserts. The spindle diameters range from 1/4" to 2". When changing spindles, the table insert will need to be changed to the matching size. Each plate has notch ( 
) to fit the alignment pin ( 
) in the table to ensure that it is properly fitted and installed in the table opening.
There are 2 insert plates with oblong openings and 2 with round openings. The oblong insert plates are used when the table is tilted for bevel sanding.
FAILURE TO USE THE PROPER INSERT WITH THE CORRESPONDING SPINDLE MAY RESULT IN INJURY AND/OR DAMAGE TO THE MACHINE OR THE WORKPIECE.
The following chart explains which inserts can be used for different diameter spindles.
SPINDLE DIAMETER | TABLE INSERT (OPENING SHAPE/SIZE) |
|
|
1/4” | . . .#86 (ROUND) & #87 (OBLONG) |
1/2” | . . .#86 (ROUND) & #87 (OBLONG) |
5/8” | . . .#86 (ROUND) & #87 (OBLONG) |
. . .#85 (ROUND) & #84 (OBLONG) | |
2” | . . .#85 (ROUND) & #84 (OBLONG) |
|
|
RECOMMENDED ADJUSTMENTS
SETUP FOR 90º SANDING
Step 1
Loosen both locking levers, position the table at 0° and
Step 2
With a spindle installed, place a square on the table. Rest the long section of the square against the sanding spindle. The square should be flat against the table and the spindle from all four sides.
10