CLEAN UP
Be sure to work in a well ventilated area for the entire clean up process.
Before starting the clean up process make sure the machine is not plugged into a power source. Failure to comply may lead injury or cause damage to the machine.
All unpainted surfaces are covered with a protective coating that prevents rust from forming during shipping and storage. Peel off the plastic cover from the table and remove this protective coating by rubbing with a rag dipped in kerosene, mineral spirits or paint thinner. (Dispose of potentially flammable
A putty knife, held flat to avoid scratching the surface, may also be used to scrape off the coating followed by
For optimum performance from your machine, make sure you clean all metal surfaces of the spindles with a mild solvent or kerosene.
To prevent rust, apply a light coating of paste wax or regular applications of General International “Top Saver” item
#
ASSEMBLY INSTRUCTIONS
The unit should be installed on a flat, sturdy and stable surface able to support the weight of the machine.
Never install the machine over the edge of a table or workbench.
Never lift the machine by the table; hold and lift from the insets on the cabinet.
Make sure that the switch is in “OFF” position and that the power cord is unplugged & install the red stop switch cover plate.
7