3.Attach the dust collection hose to the sander as shown in Figure 3A, insert the hose into the dust collection bag, and secure with the strings (Figure 3B).
|
|
|
|
|
|
| A |
|
| B |
|
|
|
|
|
|
|
Figure 3. Attaching dust collection hose to
sander and dust collection bag.
Operation
1.Connect the tool to compressed air.
2.Hold the sander and press the throttle lever (Figure 4) to turn the sander ON.
Throttle
Lever
Regulator
Figure 4. Sander controls.
3.Turn the regulator (Figure 4) to adjust the sanding pad speed.
4.Remove pressure on the throttle lever to stop the sanding pad.
5.When the sandpaper loses its effectiveness, disconnect the sander and replace the sandpaper.
Maintenance
Lubricate at least once every eight hours of oper- ation. Place one or two drops of pneumatic tool oil directly into the air fitting as shown in Figure 5.
Figure 5. Lubricating directly into air fitting.
Before installing the sanding disc, run the sander for a few minutes to eject excess oil, then wipe the tool down with a clean rag and begin sanding. Oil the tool after use or storage.
Service
To replace the sanding pad:
1.Disconnect the sander!
2.Insert the included wrench onto the spindle as shown in Figure 6.
Sanding
Pad
Wrench
Figure 6. Wrench inserted onto spindle.
3.Hold the wrench and unscrew the sanding pad.
4.Install a new sanding pad (Part # PH8120048) and secure it with the wrench.
If you need help with your new pneumatic tool, call our Tech Support at: (570)