SECTION 6: MAINTENANCE
Always disconnect power to the machine before performing maintenance. Failure to do this may result in serious person- al injury.
Schedule
For optimum performance from your machine, follow this maintenance schedule and refer to any specific instructions given in this section.
Before Each Use, Check and Correct:
•Loose mounting bolts.
•Damaged or worn sanding belt.
•Worn or damaged wires.
•Any other unsafe condition.
After Each Use:
•Clean/vacuum dust buildup on table and motor.
Model H3140 (Mfg. after 6/02)
Cleaning
Cleaning the Model H3140 is relatively easy. Vacuum excess sawdust, and wipe off the remain- ing dust with a dry cloth. Wiping the table clean after every use ensures moisture from wood dust does not remain on bare metal surfaces.
If any resin has built up, use a resin dissolv- ing cleaner to remove it. After cleaning, treat all unpainted metal surfaces with a
Lubrication
Since all bearings are sealed and permanently lubricated, simply leave them alone until they need to be replaced.