Disc Table Bracket
The disc table bracket mounts to the left side of the sanding unit, below the disc. Use the two hex bolts and washers provided. Tighten securely. See Figure 5.
Figure 5. Disc table bracket in place.
Disc Table
1.Unscrew the table trunnion guide screws from the disc table bracket.
2.Mount the disc table to the bracket with two of the knobs and washers provided.
3.Reinstall the table trunnion guide screws into the disc table bracket so that they fit into the slots in the table trunnions.
4.Loosen the knobs to adjust the angle of the table. Figure 6 shows the disc table at an angle.
The edge of the disc table should be approxi- mately 1/16" from the edge of the sanding disc. Please note the distance from the edge of the table to the sanding disc each time you change the table angle. If any discrepancy is seen, sim- ply pull the table slightly so that it is lined up prop- erly.
Figure 6. Sanding disc table in place.
|
|
|
|
|
|
|
|
|
|
|
|
G3105 Combination Sander | |||