3.To install a Sanding Belt, loosen the Belt Tensioning Screw (41) located on the Adjusting Bar (36). Place the belt over the Belt Wheel (44). Push the Belt Wheel (44) against the work bench to collapse the Adjusting Bar (36), allowing the belt to attach over the Driving Belt Wheel (47) at the motor end. Manually rotate the belt to make sure that it is centrally located on the two belt wheels. Make sure the Belt Wheel (44) center screw is tight at all times. (See Figure C.)
FIGURE C | BELT TENSIONING SCREW (41) |
BODY (1)
BELT | SANDING BELT | ADJUSTING BAR (36) | BELT |
WHEEL |
|
| WHEEL |
(47) |
|
| (44) |
4.Loosen the Clamp Screw (52) with the supplied Hex Wrench (51). Rotate the Adjusting Bar (36) to the desired position and tighten the Clamp Screw (52).
5.Connect a compressed air supply hose (not included) to the previously installed Quick Connector. Then turn on the air compressor, and set its regulator to 90 PSI. Do not exceed 90 PSI. (See Figure D.)
FIGURE D
CLAMP SCREW (52) | AIR |
| |
| SUPPLY |
| HOSE |
| (NOT INCLUDED) |
OPERATING INSTRUCTIONS
Read the entire Important Safety Information section at the beginning of this manual including all text under subheadings therein before set up or use of this product.
1.CAUTION! Prior to using the Sander, make sure to wear ANSI- approved safety impact goggles, dust mask or respirator, and heavy duty work gloves.
2.Use clamps (not included) or other practical ways to secure and support the workpiece to a stable platform. Holding the work by hand or against your body is unstable and may lead to loss of control.
SKU 97055 | For technical questions, please call | Page 8 |