ASSEMBLY INSTRUCTIONS
IMPORTANT
Carefully inspect the condition of the accessory before use and check the accessory continually during use. If any damage is noted, stop immediately and replace the accessory with an undamaged one. Harbor Freight Tools cannot be held responsible for damage caused by using a damaged accessory on this tool.
NOTE: For additional references to the parts listed below, refer to the Assembly Diagram on page 11 of this manual.
To Attach The Polishing Disc And Wool Cover:
1.Caution: Prior to installing the Wool Compounding Bonnet (part #44), make sure the Polisher/Sander is disconnected from its electrical power source.
2.Place the Adaptor (part #1) on the Spindle (part #3) of the Polisher/Sander, and place the Wool Compounding Bonnet (part #44) on the Adaptor (See Figure B, and Assy. Diagram.)
3.Depress the Brake Pin (part #18) to keep the Spindle (part #3) from turning, and hand screw the Adaptor (part #1) onto the Spindle. (See Figures B, C, and Assy.
Diagram.)
4.Then, use the Spanner (part #43) provided to keep the Adaptor (part #1) from turning, and firmly hand tighten the Wool Compounding Bonnet onto the Adaptor.
(See Figures B, C, and Assy. Diagram.)
ADAPTOR (#1)
SPINDLE (#3)
|
|
|
|
|
|
|
|
|
|
|
|
|
| BRAKE PIN (#18) | |
|
|
|
|
|
|
|
|
|
|
|
|
|
| ||
|
|
|
|
|
|
|
|
|
|
|
|
|
| ||
|
|
|
|
|
|
|
|
|
|
|
|
|
| ||
|
|
|
|
|
|
|
|
|
|
|
|
|
| ||
|
|
|
|
|
|
|
|
|
|
|
|
|
| BRUSH CAP (#40) | |
|
|
|
|
|
|
|
|
|
|
|
|
|
| ||
|
|
|
|
|
|
|
|
|
|
|
|
|
| ||
|
|
|
|
|
|
|
|
|
|
|
|
|
| CARBON BRUSH (#41) | |
|
|
|
|
|
|
|
|
|
|
|
|
|
| ||
|
|
|
|
|
|
|
|
|
|
|
|
|
| BRUSH HOLDER (#42) | |
|
|
|
|
|
|
|
|
|
|
|
|
|
| (Qty. 2 EACH) | |
WOOLCOMPOUNDING BONNET (#44) | |||||||||||||||
|
|
|
|
| |||||||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
| VARIABLE SWITCH (#31) | |
| SWITCH (#33) |
|
|
|
|
|
|
|
| SWITCH LOCK | |||||
|
|
|
|
| |||||||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
| BACK HANDLE (#39) |
FIGURE B
SKU 46507 | PAGE 6 | REV 09/02 REV 06/05 |