Harbor Freight Tools 97181 manual Specifications, Unpacking, Initial Set Up Instructions, Assembly

Page 9

Specifications

 

Housing: Sheeted

 

Steel

 

Roller and Block

Construction Materials

Stop: Polyethylene

 

Hardware: Carbon

 

Steel

 

Feet: Rubber

Sanding Disc

6”

 

 

Sanding Belt

4” W X 36” L , 80 Grit

 

3/4 HP PEAK

Motor and Electrical

120V

60Hz,

Information

Amps - With Load:

 

 

3.5 AMP’S

Plug

3-Prong Grounded

Belt Speed

1150 FPB

Disc Speed

1780 RPM

Unpacking

When unpacking, check to make sure that the item is intact and undamaged. If any parts are missing or broken, please call Harbor Freight Tools at the number shown on the cover of this manual as soon as possible.

Initial Set Up

Instructions

Read the entire Important Safety Information section at the beginning of this manual including all text under subheadings therein before set up or use of this product.

To prevent

WARNING serious injury from

accidental operation: Turn the Power Switch of the Belt/Disc Sander to its “OFF” position and unplug the tool from its electrical outlet before assembling or making any adjustments to the tool.

Note: For additional information regarding the parts listed in the following pages, refer to the Assembly Diagram near the end of this manual.

Assembly

Feet Placement

1.Carefully set the Belt/Disc Sander on its side.

Figure 1

Rubber Pads (28)

2.Press each Rubber Pad (28) over the lip of the Base at each corner. (See Figure 1)

SKU 97181

For technical questions, please call 1-800-444-3353.

Page 9

Image 9
Contents 6 belt/disc sander Contents General Safety Rules Work area safetySave This Manual Electrical safety Personal safetyPower tool use and care Vibration Hazard ServiceV e t h e s e instructions Specific Safety RulesProng Plugs GroundingExtension Cords OutletSymbology See Table a25’ 50’ 75’ Initial Set Up Instructions SpecificationsAssembly Feet PlacementMounting Table for use as Disc Sander Mounting Aluminum DiscMounting Table for use as Belt Sander See Figures 6 Mounting Stop PlateOperating Instructions FunctionsMaintenance Servicing Cleaning, Maintenance, LubricationMounting Sanding Discs Sanding Belt Replacement Belt ReplacementPort 59 after cleaning and tighten Screw Troubleshooting Problem Possible Causes Likely SolutionsBelt Tensioning Record Product’s Serial Number Here Please Read the Following CarefullyPart Description ’ty Parts ListAssembly Diagram Limited 1 year / 90 Day warranty